[mdlug-newbie] Burning DVDs

[Joseph Bennett]

Ingles, Raymond wrote:
>> From: Joseph Bennett
>>     
>
>   
>
>  When you put in a blank DVD, run "dmesg | tail" and see what it says. If the
> kernel isn't recognizing that a blank has been inserted, the GUI won't either.
> If the kernel does see it, then you know the problem's higher up.
>
>  Sincerely,
>
>  Ray Ingles                                           (313) 227-2317
>
>  
>   
Ray Ingles...

I did the dmesg thing and this is what I got:
>
> newpc:~ # dmesg | tail
> PM: Writing back config space on device 0000:0a:0b.0 at offset 2 (was
> 2000000, w                          riting 2000003)
> PM: Writing back config space on device 0000:0a:0b.0 at offset 1 (was
> 2b00000, w                          riting 2b00106)
> PM: Writing back config space on device 0000:0a:0b.0 at offset 0 (was
> 165314e4,                           writing 165414e4)
> ADDRCONF(NETDEV_UP): eth0: link is not ready
> tg3: eth0: Link is up at 100 Mbps, full duplex.
> tg3: eth0: Flow control is off for TX and off for RX.
> ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
> NET: Registered protocol family 17
> bootsplash: status on console 0 changed to on
> eth0: no IPv6 routers present
> newpc:~ #
>
>
>
> Question: What should I have gotten?  All of this is French to me.
I do appreciate your help and your patience (it will take a lot).

Joe B.....



-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mdlug.org/pipermail/mdlug-newbie/attachments/20071203/ca98a0bd/attachment-0001.html>