<!DOCTYPE html PUBLIC "-//W3C//DTD HTML 4.01 Transitional//EN">
<html>
<head>
<meta content="text/html;charset=ISO-8859-1" http-equiv="Content-Type">
<title></title>
</head>
<body bgcolor="#ffffff" text="#000000">
Ingles, Raymond wrote:
<blockquote
cite="mid41C33488FEC67C43BC564F5F086C21FF0ABBACE0@nasa-dtw-ex001.nasa.cpwr.corp"
type="cite">
<blockquote type="cite">
<pre wrap="">From: Joseph Bennett
</pre>
</blockquote>
<pre wrap=""><!---->
</pre>
<pre wrap=""><!---->
When you put in a blank DVD, run "dmesg | tail" and see what it says. If the
kernel isn't recognizing that a blank has been inserted, the GUI won't either.
If the kernel does see it, then you know the problem's higher up.
Sincerely,
Ray Ingles (313) 227-2317
</pre>
</blockquote>
Ray Ingles...<br>
<br>
I did the dmesg thing and this is what I got:<br>
<blockquote type="cite"><br>
newpc:~ # dmesg | tail<br>
PM: Writing back config space on device 0000:0a:0b.0 at offset 2 (was
2000000, w riting 2000003)<br>
PM: Writing back config space on device 0000:0a:0b.0 at offset 1 (was
2b00000, w riting 2b00106)<br>
PM: Writing back config space on device 0000:0a:0b.0 at offset 0 (was
165314e4, writing 165414e4)<br>
ADDRCONF(NETDEV_UP): eth0: link is not ready<br>
tg3: eth0: Link is up at 100 Mbps, full duplex.<br>
tg3: eth0: Flow control is off for TX and off for RX.<br>
ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready<br>
NET: Registered protocol family 17<br>
bootsplash: status on console 0 changed to on<br>
eth0: no IPv6 routers present<br>
newpc:~ #<br>
<br>
<br>
<br>
Question: What should I have gotten? All of this is French to me.<br>
</blockquote>
I do appreciate your help and your patience (it will take a lot).<br>
<br>
Joe B.....<br>
<br>
<br>
<br>
</body>
</html>